I disabled comments on this video because I kept getting the same stupid comments over and over from clueless people. \r
\r
Following the copious number of suggestions from the gallery on reducing the speed while drilling hardened steel, I tried it out. I also tried drilling at high speed to compare. \r
Based on the limited data collected from these tests, Id say that drilling at a moderate speed and lubricating yields the best results.\r
\r
I turned comments off on this video because it was getting too many from people that did not watch the first video and are completely clueless as to what I was doing here.\r
\r
You can help to support high quality projects and videos on this channel with Patreon:
