Quick Release Belt Drive Feeding. The "Pins"
The "Pins"
One Pin is used to hold the skateboard bearing and the other Pin which has a hole in for a 4mm bolt is to pivot that bolt for quick release of the filament.
Other parts for this "Quick Release Belt Drive Feeding" to follow.
I am using Cura 15.04.2 to slice onto a SD card for use in LCD12864 graphics display controller driving RAMPS 1.4 via Marlin
BLTouch Probe used for Auto Home and bed leveling. Very helpful.
Antclabs
http://www.antclabs.com
Protomaker Black Sprint Original 3D Printer
Cura* to slice into G-code that is placed onto a SD Card which is put in a LCD 12864 Display controller.
PLA Black 1.75mm*, E3D v6 Nozzle 0.4mm
190° C Hotend all layers.
Heat Bed 70° C
Infill set to 80%. Layers 0.06 {fine}
No supports or raft.
Retraction set to 0.7mm at 40mm/s
Surface Blue Painters Tape cleaned with Isopropyl alcohol.
BLTouch Classic Auto Leveling Probe Antclab website
http://www.antclabs.com
* PLA measured at 1.70mm
This Quick Release Belt Drive Feeding is based on:-
This is a MXL Belt Bowden Extruder 1.75mm
http://www.thingiverse.com/thing:581170
The eBay seller who made the feeder used to make this print was very helpful and went that extra mile to help me
http://www.ebay.co.uk/usr/pilvytis
.
